Multiple Digital Message Unit | Bogen LUMDMU instruction

Lucent Technologies

Bell Labs Innovations

Multiple Digital Message Unit

Installation and Use Manual

Issue 1, October 1999

© 1999 Bogen Communications, Inc. All rights reserved. 54-2024-01 9910 Model: LUMDMU

PEC Code: 5325-100

COM Code: 408184000

Select Code: 701-000-117

Image 1

Bogen LUMDMU manual Multiple Digital Message Unit

Contents

Multiple Digital Message Unit Domestic and International Approvals Table of Contents Before You Start Introduction Have Required Tools Installation Steps Rack Mounted Mdmu Connect the Mdmu to the Telephone System Mdmu Connection to Over Ride Table below Set the Mdmu options on the DIP switch. Refer to Push the Battery slide switch to the on position Power Up System Front Panel Operation Controls and IndicatorsRecording Messages When recording is complete, press the Func key Listening to Recorded Messages Press the Func button until Play is displayed Playing MessagesPress the RUN button Than MSG-01 to play Playing Messages in Sequence You are configured for 8 seePress the Func button to select a message other Press RUN to play and group the message Adding a Time Delay Between Message Plays Press RUN to clear the message sequence Clearing a Message Sequence Press the Func button until Time appears Checking Message Times Audio and Memory Tests Reset Delay Times to Default Test Button to end the continuous audioButton until Test appears Button to select the memory test Telephone Access Operation Playing Messages On the next page give the Aux. Connector pin-out definitions Specifications PIN Wire Colors Definition Blue White J1 Ring Orange