Clearing a Message Sequence | Bogen LUMDMU instruction

Clearing a Message Sequence

1

2

3

4

The message sequence can be cleared leaving the individual messages to be played separately.

Press the FUNC button until PLAY is displayed

PLAY

Press the RUN button.

MSG-01

Press the FUNC button until the following message is displayed.

MSG-00

This is the message abort number.

Press RUN to clear the message sequence.

CLEARED

DONE

IDLE

13

Image 16

Bogen LUMDMU manual Clearing a Message Sequence, Press RUN to clear the message sequence

Contents

Multiple Digital Message Unit Domestic and International Approvals Table of Contents Introduction Before You Start Installation Steps Have Required Tools Connect the Mdmu to the Telephone System Rack Mounted Mdmu Mdmu Connection to Over Ride Set the Mdmu options on the DIP switch. Refer to Table below Power Up System Push the Battery slide switch to the on position Front Panel Operation Controls and IndicatorsRecording Messages When recording is complete, press the Func key Listening to Recorded Messages Playing Messages Press the Func button until Play is displayedPress the RUN button Than MSG-01 to play You are configured for 8 see Playing Messages in SequencePress the Func button to select a message other Press RUN to play and group the message Adding a Time Delay Between Message Plays Clearing a Message Sequence Press RUN to clear the message sequence Checking Message Times Press the Func button until Time appears Reset Delay Times to Default Audio and Memory Tests Button to end the continuous audio TestButton until Test appears Button to select the memory test Telephone Access Operation Playing Messages Specifications On the next page give the Aux. Connector pin-out definitions PIN Wire Colors Definition Blue White J1 Ring Orange