Playing Messages | Bogen LUMDMU instruction

Playing Messages

1

2

Dial the telephone extension of the MDMU.

Dial the message number to play over the public

address system (for example, 14, for message number 14).

The message is played and added to the sequence of messages playing.

Press the # key to disconnect from the MDMU.

Clearing a Message Sequence

1

2

3

Dial the telephone extension of the MDMU.

Press 0 (or 00 if set for 99 messages).

This action removes all messages from the sequence, stops any contact closure message starts, and places the MDMU in the IDLE state.

Press the # key to disconnect from the MDMU.

18

Image 21

Bogen LUMDMU manual Playing Messages

Contents

Multiple Digital Message Unit Domestic and International Approvals Table of Contents Before You Start Introduction Have Required Tools Installation Steps Rack Mounted Mdmu Connect the Mdmu to the Telephone System Mdmu Connection to Over Ride Table below Set the Mdmu options on the DIP switch. Refer to Push the Battery slide switch to the on position Power Up System Controls and Indicators Front Panel OperationRecording Messages When recording is complete, press the Func key Listening to Recorded Messages Press the Func button until Play is displayed Playing MessagesPress the RUN button Than MSG-01 to play Playing Messages in Sequence You are configured for 8 seePress the Func button to select a message other Press RUN to play and group the message Adding a Time Delay Between Message Plays Press RUN to clear the message sequence Clearing a Message Sequence Press the Func button until Time appears Checking Message Times Audio and Memory Tests Reset Delay Times to Default Test Button to end the continuous audioButton until Test appears Button to select the memory test Telephone Access Operation Playing Messages On the next page give the Aux. Connector pin-out definitions Specifications PIN Wire Colors Definition Blue White J1 Ring Orange