Removing | the | transport |
| assemblies. | Slide each | loosened |
| |||||||||
bolts |
|
|
|
|
|
| transport bolt assembly out of its |
| ||||||||
|
|
|
|
|
|
| retaining | slot, | then | pull | it out through | |||||
d | CAUTION |
|
| the round | hole | in | the | housing. |
| |||||||
| q | If the bushings do not come out |
| |||||||||||||
|
|
|
|
|
|
| ||||||||||
To avoid |
| possible | injury | and damage | when | removing | the | bolts, place the | ||||||||
| bolts | back | into | the | bushings | and |
| |||||||||
to the appliance and adjacent |
|
| ||||||||||||||
| carefully | try | again. | It | is important | to | ||||||||||
surfaces, all four transport bolts |
| |||||||||||||||
must be removed before using the | do this with the bolts, otherwise the | |||||||||||||||
appliance. |
| Retain | the | bolts for | use | bushings | will | not come | out | properly. | ||||||
in any future transport (e.g. when | To store | the | bolts | for | future | use, | do | |||||||||
moving). |
| If | you have | purchased | a q | |||||||||||
pedestal mounting kit, follow the |
| not remove the bolts from the |
| |||||||||||||
installation | instructions provided |
| plastic | bushings. |
|
|
|
|
| |||||||
with it before removing the transport |
|
|
|
|
|
|
|
|
|
| ||||||
bolts. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
qLoosen all four bolts before removing any of the bolts all the way from the unit.
qRemove the bottom two bolts prior to removing the top two bolts. Remove the bolts in the order shown in the diagram below.
qLoosen the bolts using the closed end of the 1/2" wrench provided. Loosen them until they can be req moved freely.
qThe recessed bottom bolts may be easier to removeusing a 1/2" (13 mm) socket wrench.
qPosition the plastic cover over the hole the transportation bolts occupied. Push the tab in (A) and slide the cover towards the small slot (B).
Storing the transport bolts
Always keep the transport bolts for fuq ture transportation of the appliance (such as when moving out).
qStore the transport bolts with the washer and bushing attached.
qCompletely remove all 4 transport bolt assemblies (bolt, spring, washer and bushings). Pull the washer drum slightly forward towards the open washer door to reduce pressure on the transport bolt
8
