Bosch Appliances F220-B6RS General Information, 2.1.1Compatible Control Panels

F220 Series Detectors with F220-B6RS Bases		General Information en 3
	use a can of clean, dry compressed air (such as TECHSPRAY
	ENVI-RO-TECH Duster) which is available at office and alarm
	supply stores. Shorten the plastic tube that comes with the
	compressed air to about 2 in. (5 cm). Place the tube or needle
	valve through the Chambermaid valve in the bottom of the
	detector (refer to Figure 2.2 on page 6).
i	NOTE! Do not paint the detectors. Paint or other foreign
	matter covering the detector can prevent smoke
	detection.
2	General Information
	This document covers mounting, wiring, power requirements,
	testing, and maintenance for the F220-B6RS Detector Bases
	and the F220 Series Heat and Photoelectric Smoke Detectors.
	Install them according to NFPA 72.
i	NOTE! For proper system installation, read and
	understand NFPA 72 before installation.

For installation guidelines, refer to Installation Considerations for Smoke and Fire Detectors (P/N: 26715).

2.1F220-B6RS Detector Bases

The F220-B6RS is a four-wire base with a Form A alarm relay and a built-in sounder. Other bases (two-wire and four-wire without built-in sounders) are available. Refer also to the F220 Series Detectors with F220-B6/C/E/R Installation Instructions (P/N: 4998138694) and the F220-B6PS/M Installation Instructions (P/N: 4998149982).

2.1.1Compatible Control Panels

The F220-B6RS is a four-wire base compatible with all UL Listed four-wire control panels. Refer to the control panel

Bosch Security Systems, Inc. Installation Manual F.01U.029.847 -01 2007.02