Bosch Appliances VIP X1 manual General malfunctions, Malfunction Possible causes Solution

EN 124Installation and Operating Manual VIP X1

General malfunctions

Malfunction	Possible causes	Solution
No connection	Incorrect cable connections.	Check all cables, plugs, contacts,
between the unit and		terminals and connections.
terminal program.
	The computer's serial inter-	Check the other serial interface.
	face is not connected.
	Interface parameters do not	If necessary select a different inter-
	match.	face and make sure that the com-
		puter's interface parameters match
		those of the unit. Try the following
		standard parameters:
		19,200 baud, 8 data bits, no parity,
		1 stop bit. Next, disconnect the unit
		from the power supply and recon-
		nect it again after a few seconds.
No image transmis-	Camera error.	Connect local monitor to the cam-
sion to remote sta-		era and check the camera function.
tion.
	Faulty cable connections.	Check all cables, plugs, contacts
		and connections.
No connection estab-	The unit's configuration.	Check all configuration parame-
lished, no image		ters.
transmission.
	Faulty installation.	Check all cables, plugs, contacts
		and connections.
	Wrong IP address.	Check the IP addresses
		(terminal program).
	Faulty data transmission	Check the data transmission with
	within the LAN.	ping.
	The maximum number of	Wait until there is a free connection
	connections has been	and then call the sender again.
	reached.
No audio transmis-	Hardware fault.	Check that all connected audio
sion to remote sta-		units are operating correctly.
tion.
	Faulty cable connections.	Check all cables, plugs, contacts
		and connections.
	Incorrect configuration.	Check the audio parameters on the
		Audio settings and Livepage
		configuration configuration
		pages.
	The audio voice connection	Wait until the connection is free
	is already in use by another	and then call the sender again.
	receiver.

Appendix Bosch Security Systems 2006-12 V2.5