VIP X1 Installation and Operating Manual | EN 125 |
|
|
Malfunction | Possible causes | Solution |
The unit does not | Alarm source is not selected. | Select possible alarm sources on |
report an alarm. |
| the Alarm sources configuration |
|
| page. |
|
|
|
| No alarm response speci- | Specify the desired alarm response |
| fied. | on the Alarm connections config- |
|
| uration page, change the |
|
| IP address if necessary. |
|
|
|
Control of cameras | The cable connection | Check all cable connections and |
or other units is not | between the serial interface | ensure all plugs are properly fitted. |
possible. | and the connected unit is not |
|
| correct. |
|
|
|
|
| The interface parameters do | Make sure that the settings of all |
| not match those of the other | units involved are compatible. |
| unit connected. |
|
|
|
|
The unit is not opera- | Power failure during pro- | Have the unit checked by Cus- |
tional after a firm- | gramming by firmware file. | tomer Service and replace if nec- |
ware upload. |
| essary. |
|
|
|
| Incorrect firmware file. | Enter the IP address of the unit fol- |
|
| lowed by /main.htm in your Web |
|
| browser and repeat the upload. |
iSCSI connections malfunctions
Malfunction | Possible causes | Solution |
No LUNs are dis- | Incorrect LUN mapping dur- | Check the iSCSI server configura- |
played after connec- | ing iSCSI server configura- | tion and reconnect. |
tion to the iSCSI | tion. |
|
server. |
|
|
|
|
|
„LUN FAIL“ is dis- | The LUN map was not read- | Check the iSCSI server configura- |
played below a node | able as it was assigned to | tion and reconnect. |
after connection to | the wrong network interface. |
|
the iSCSI server. |
|
|
|
|
|
LUN mapping is not | Some iSCSI systems don’t | Delete the initiator extension on the |
possible. | support initiator extensions. | iSCSI settings configuration page. |
|
|
|
Bosch Security Systems | Appendix |