Adjustments
Blade Square to Fence
1.Make sure head assembly is pushed forward near the center of the table and slide rail lock knob is tightened.
2.Lower the head assembly, pull the lock pin out and rotate it 90°, rotate to lock the head assembly in the down position. Make sure table is in 0° detent and tighten miter lock knob. Place a com- bination square against the fence and next to the blade as illustrated. Locate the square properly so it does not contact the tooth of saw blade. The saw blade should contact the full length of the square (Figure 9).
3.If blade does not contact the square, follow the fence alignment procedure.
Fence
Blade
Combination Square
Figure 9. Blade Square to Fence
Fence alignment
a. Remove sliding fence extensions.
b. The head assembly should remain in lowered position.
c. Use multi purpose wrench (supplied) and loosen four (4) hex bolts behind fence (Figure 10).
d. Adjust fence until blade and the fence has full contact with the square.
e. Tighten hex bolts.
f.
Hex Bolts
Figure 10. Fence Adjustment
Miter Scale
Indicator Adjustment
1.Rotate table to 0° position and lock in place.
2.Raise the head assembly to the
3.Loosen the Phillips screw that holds the indicator in place (Figure 11).
4.Position the indicator to align with the 0° miter mark. Tighten the screw.
60 55 
50 
45 
40
|
|
|
|
|
|
|
| 0 |
|
|
|
|
|
| 2 | 12 | 0 |
|
|
|
| 4 | 12 |
|
| |
2 | 8 12 | 6 12 |
|
|
| 5 | ||
|
|
|
| |||||
|
|
|
|
|
| |||
|
|
|
|
|
| 15 |
| 10 |
|
|
|
|
| 20 |
|
| |
| 35 | 30 | 25 |
|
|
|
| |
|
|
|
|
|
|
0° Mark
Miter Scale
Indicator
Indicator
Adjustment
Screw
Figure 11. Miter Scale Adjustment
15.
