Electrical Requirements
1.Connect this saw to a 120V,
2.Fuses may “blow” or circuit breakers may trip frequently if motor is overloaded. Overloading can occur if you feed the blade into the work- piece too rapidly or start and stop too often in a short time.
3.Most motor troubles may be traced to loose or incorrect connections, overload, low voltage (such as small size wire in the supply circuit or too overly long supply circuit wire). Always check the connections, the load and the supply circuit whenever motor does not work well.
Electric Brake
Your saw is equipped with an automatic electric brake which is designed to stop the blade from spin- ning in about five (5) seconds after you release the trigger switch. It is useful when making certain cuts in wood where a coasting blade would result in a wide, imprecise cut.
! WARNING | When electrical power is lost due to |
blown fuse or other causes, the |
motor will gradually slow down and the braking action is initiated ONLY by the release of the trigger switch.
The electric blade brake of your miter saw has been designed for highest degree of reliability, but unex- pected circumstances such as contamination on the commutator and brushes or failure of motor’s compo- nents can cause the brake not to activate. If this con- dition occurs, turn the saw “ON” and “OFF” four to five times without contacting the workpiece. If the tool operates but the brake does not consistently stop the blade in about five (5) seconds, DO NOT use saw and have it serviced immediately.
The brake action of this saw is not intended as a safety feature.
Remember to let the saw blade come to a complete stop before raising the blade from the workpiece. As always the guard system is your best protection against unintentional contact with a spinning saw blade. NEVER wedge open or defeat the closing action of the lower guard.
7.
