Assembly
Tools Needed For Assembly And Alignment
Combination Square | Hex “L” Wrench | Multi Purpose Tool | |||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| (supplied) 1.5mm | (supplied) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Combination Square Must be True
Draw Light | Straight Edge of | ||
Line on Board | Board 3/4" Thick | ||
Along this Edge | This Edge Must be | ||
|
| Perfectly Straight | |
|
|
|
|
Should be no Gap or Overlap |
|
|
|
when Square is Flipped Over in |
|
|
|
Dotted Position |
|
| |
10mm/17mm Combination Open End Wrench
! WARNING | Disconnect plug from power source before performing any assembly, adjustment or repair to | |
avoid possible injury. | ||
|
Unpacking And Checking Contents
! WARNING | Before moving the saw: Lock the | |
miter lock knob in 45° position. Lock | ||
|
bevel lock handle. Pull the head assembly complete- ly toward you and tighten the slide rail lock knob.
Lock head assembly in the down position.
Never carry the tool by the slide rails, this may cause blade damage.
Never carry the tool by the cord or head assembly power switch handle. Damage to insulation could cause an electric shock. Damage to wire connections could cause a fire.
Model 4412 Miter Saw is shipped complete in one box.
1.Separate all parts from packing materials and check each one with the “Table of Loose Parts” to make sure all items are accounted for before dis- carding any packing material.
2.Table of Loose Parts:
Quick- Action Clamp - Used to clamp workpieces. Dust Elbow/Dust Bag - Used to collect saw dust.
Multi Purpose Tool - Should be stored on the right rear base.
Rear Cord Wrap, washer and Screw - Used for wrapping the cord
Miter Lock Knob - Used to lock the table at desired miter angle.
! WARNING | If any parts are missing, do not plug | |
in power cord or turn the switch on | ||
|
until the missing parts are obtained and are installed correctly.
Attaching Miter Lock Knob
Locate the miter gauge lock knob from among the loose parts, and thread shaft on lock knob into hole provided.
Miter Gauge
Lock Knob
UNLOCK
LOCK
Attaching Rear Cord Wrap
Locate the rear cord wrap from among the loose parts, position rear cord wrap as shown and secure with washer and phillips screw provided.
Rear Cord Wrap
Washer
Phillips Screw
10.
