Router Table Assembly
ASSEMBLING THE ROUTER TABLE
TABLE LEG INSERTS (FIG. 1)
The router table includes two table leg inserts:
•Leg storage panel (7) for convenient storage of acces- sories
•Leg cord wrap panel (8)
The table leg inserts must be installed before attaching the tabletop.
1.Place the table leg insert (7 or 8) into the opening in the table leg (6) so that it is positioned at the very top of the opening.
FIG. 1
7
8
66
2.Press the insert in so that it is completely flush with the leg.
3.Push the insert down as far as it will go to lock it in place.
NOTE: The cord wrap panel has two tabs at the top of the panel that lock under the table top. These tabs help prevent the panel from coming unhooked when wrapping or unwrapping the cord.
TOOLS REQUIRED (not included) |
|
| |
FIG. 2 | |||
• | Phillips screwdriver |
| 31 |
• | Small sized adjustable wrench |
|
|
• | Tape with adhesive backing (optional) |
|
|
ROUTER TABLE LEGS (FIG. 2)
1. Insert eight | 1 |
through the router tabletop (1) as shown in Fig. 2. |
|
2.Assemble the legs (6) to the router table as shown in the figure.
3.Assemble a 9/32″ ID x 5/8 OD″ x 1/16″ thick washer (27) and a
4.Securely tighten the fasteners.
NOTE: It may be easier to assemble the legs by laying the router table on its front or back, or by using adhesive tape over the carriage bolt heads to hold them in place and turning the router table upside down.
27
26
6
10
