Bosch Power Tools RA118EVSTB, RA1181 manual GROOVING, FLUTING, and Veining, Figs, Before proceeding

Router Table Operation

GROOVING, FLUTING, AND VEINING		FIG. 30
(Figs. 30 and 31)
	ALWAYS MAKE SURE THAT THE
ROUTER IS TURNED OFF AND THE POWER CORD
IS UNPLUGGED BEFORE MAKING ANY
ADJUSTMENTS.
NOTE: If the jointing shim is installed, remove it
before proceeding.
When performing these routing operations, the use of
featherboards and a push shoe is recommended.
For best results and maximum accuracy, the side of the
workpiece that will be against the fence must be square
and straight.
If you are using a wet/dry vac, it should be connected
to the vac port on the back of the table cabinet.		FIG. 31

LOCATION OF CUT

FENCE

FACING

END CUTTING

ROUTER BIT

HEIGHT

OF CUT

Guard not shown for clarity

1.	Install the desired end-cutting bit in the router.	WORKPIECE
2.	Follow the instructions on page 26 to set the desired
	depth of cut (location of cut) and height of cut
	(Fig. 30). Make sure that the fence and router
	are SECURELY in place.

IMPORTANT: For deep cuts, do not try to cut the total depth (controlled by the router bit height) all in one pass. Repeat the cut, taking smaller cuts until the desired depth is reached.

3. Position both fence facings so that they provide con- tinuous support of the workpiece.

4. Tighten the four clamping knobs holding the fence facings in place.

5.Position the featherboards, if desired. See ROUTING USING FEATHERBOARDS on page 25.

6.Remove the board from the table and lower the overhead guard to the operating position. Tighten the guard clamping knobs SECURELY.

NOTE: When making adjustments, use a piece of scrap wood to make trial cuts before making the cut with the actual workpiece.

7.Make sure that both the router and switch box are OFF; then plug the router into the switch box.

8.While firmly holding a piece of scrap wood against the fence and down against the router table, feed a piece of scrap wood toward the bit in the direction shown by the arrow in Fig. 31.

9.Using the switch box, turn the router OFF. If any adjustments are needed, unplug the power cord and repeat steps 2–8 until all adjustments are correct. Once you are satisfied with all settings, make the cut with the actual workpiece.

30