Router Table Assembly
ALWAYS MAKE SURE THAT THE ROUTER IS TURNED OFF AND THE POWER CORD IS UNPLUGGED BEFORE MAKING
ANY ADJUSTMENTS.
TABLETOP INSERTS (Fig. 16)
This router table includes three tabletop inserts with the following hole sizes:
•1″ in diameter (3), for use with bits with diameters up to 7/8″
•2″ in diameter (4), for use with bits with diameters up to 17⁄8″
•23⁄4″ in diameter (5), for use with bits with diameters up to 25⁄8″
No insert is used for bits with diameters over 25⁄8″ and up to 31⁄2″.
Do NOT use the router table with bits over 31⁄2″ in diameter!
TO INSTALL TABLETOP INSERTS (Fig. 16):
1.Select the tabletop insert that best accommodates the router bit to be used.
2.Press the insert into the large hole in the router mounting plate (Fig. 16). If the fence is in the way, loosen the clamping knobs on the fence support brackets and slide the fence back out of the way.
3.Press down evenly over the tabs until the insert locks into place.
4.To remove, pull up gently until the tabs disengage. When not in use, store tabletop inserts behind the storage panel in the table leg or in another convenient place.
DO NOT attempt to remove tabletop inserts from the tabletop unless the router is unplugged.
FIG. 16
| 1″ HOLE (3) |
35⁄8″ HOLE | 2″ HOLE (4) |
IN ROUTER | |
MOUNTING |
|
PLATE | 23⁄4″ HOLE (5) |
|
20
