Bosch Power Tools RA118EVSTBPLUS Installing the Router Mounting Plate, Tools Required, Figs a -7C

Router Table Assembly

INSTALLING THE ROUTER MOUNTING PLATE

TOOLS REQUIRED

•1/8″ Allen wrench (32) (included)

•Phillips screwdriver (not included)

•Straight edge (not included)

•Small-sized adjustable wrench (not included)

NOTE: The fences must NOT be installed on the router table for the following procedures.

PRELIMINARY INSTALLATION OF THE ROUTER MOUNTING PLATE

(Figs. 7A –7C)

1.Completely thread a #10-32 ESNA stop nut (25) onto each of the eight #10-32 x 3/4″ countersunk socket-head screws (29) as shown in Fig. 7A. The orientation of the stop nut on the screw must be as shown in Fig. 7A.

NOTE: It will be helpful to use the included Allen wrench and an adjustable wrench because the nut has tight-fitting threads.

2.Place the eight assembled screws and nuts into the eight hex-shaped pockets in the recess on the tabletop as shown in Fig. 7B.

The screw threads are to be inserted into the holes at the bottom of the pockets.

3.Place the router mounting plate into the opening in the tabletop so that it rests on the heads of the screws as shown in Fig. 7B.

4.Position a straight edge or level across the mounting plate as shown in Fig. 7C. The straight edge must be long enough to extend completely over the opening in the router tabletop.

5.Insert the Allen wrench (32) through the eight round holes in the mounting plate, engaging the hex socket in the screw heads (Fig. 7C).

6.Raise and lower the mounting plate by turning the screws until the mounting plate is level and flush with the top of the router table.

7.Remove the mounting plate from the tabletop.

NOTE: It may be necessary to make slight adjustments after final installation of the router adapter plate.

FIG. 7A 29

25

FIG. 7B

FIG. 7C

	1/8″ ALLEN
STRAIGHT EDGE	WRENCH (32)

13