Bostitch BTFP02006 instruction manual Code Possible cause, Solution. Do Not Overtighten

Air leaks from safety valve			6
Knocking Noise			6,16,17
Pressure reading on the regulated pressure gauge drops when an accessory is used....7
Compressor is not supplying enough air to operate accessories			....................8,9,10,11,12,15
Regulator knob has continuous air leak			13
Regulator will not shut off air outlet			13
Moisture in pump crankcase			14,18
Motor will not run			11,19,20,21,22,23,24,25,26
	Troubleshooting Codes
Code	possible cause	POSSIBLE SOLUTION

1Pressure switch does not Set the On/Off switch to OFF, if the unit shut off motor when com- does not shut off contact an authorized pressor reaches cut-out service center.

pressure

2	Pressure switch cut-out too	Contact an authorized service center.
	high
3	Tube fittings are not tight	Tighten fittings where air can be heard
	enough	escaping. Check fittings with soapy water
		solution. Do Not Overtighten.
4	Defective air tank	Air tank must be replaced. Do not repair the
		leak.
			Risk of bursting. Do not drill into,
		weld or otherwise modify air tank or it will
		weaken. The air tank can rupture or explode.
5	Leaking seals	Contact an authorized service center.
6	Defective safety valve	Operate safety valve manually by pulling on
		ring. If valve still leaks, it must be replaced.
7	Regulator is not adjusted	It is normal for some pressure drop to occur
	correctly for accessory	when an accessory is used, adjust the regulator
	being used	as instructed in Regulator under Features if
		pressure drop is excessive.
		NOTE: Adjust the regulated pressure under
		flow conditions while accessory is being used.
8	Prolonged excessive use	Decrease amount of air usage.
	of air
9	Compressor is not large	Check the accessory air requirement. If it is
	enough for accessory	higher than the SCFM or pressure supplied by
		air compressor, a larger compressor is needed
		to operate accessory.
10	Hole in air hose	Replace air hose.
11	Check valve restricted	Remove, clean or replace.
12	Air leaks	Tighten fittings.
13	Regulator is damaged	Replace.

14Unit operating in damp or Move unit to a dry well ventilated area humid conditions

15 Restricted air intake filter Clean or replace air intake filter

19