Briggs & Stratton Water Transfer Pump manual Connect Discharge Hose Optional

3.Slide hose clamp (A) over end of hose (B). Slide suction hose onto hose barb (C). Tighten hose clamp securely using a standard 1/4” (6mm) screwdriver.

Connect Discharge Hose (Optional)

If desired, use a commercially available hose. DO NOT use a hose with an inside diameter smaller than the pump’s discharge port size.

B

A C

1.Slide barb cuff over hose barb. Insert rubber seal into end of barb cuff as shown earler.

2.Screw hose barb assembly onto pump in clockwise rotation until hose barb assembly is tightened securely.

Attach Suction Hose to Strainer Basket

Slide hose clamp over hose. Attach open end of suction hose to strainer hose barb. Tighten hose clamp securely using a standard 1/4” (6mm) screwdriver.

3.Slide hose clamp over end of discharge hose. Slide discharge hose onto hose barb. Tighten hose clamp securely using a standard 1/4” (6mm) screwdriver.

9