Brother CPS5XVY operation manual Checking the needle, Replacing the needle, Getting Ready

GETTING READY ————————————————————————————————————————————

Checking the needle

Sewing with a bent needle is extremely dangerous since the needle may break while the machine is being operated.

Before using the needle, place the flat side of the needle on a flat surface and check that the distance between the needle and the flat surface is even.

1

2

aFlat side

bNeedle type marking

CAUTION

●If the distance between the needle and the flat surface is not even, the needle is bent. Do not use a bent needle.

1

1

aFlat surface

Replacing the needle

Replace the needle as described below. Use the screwdriver and a needle that has been determined to be straight according to the instructions in “Checking the needle”.

aPress (“Needle Position” button) once or twice to raise the needle.

1

a“Needle Position” button

bTurn off the sewing machine.

CAUTION

●Before replacing the needle, be sure to turn off the sewing machine, otherwise

injuries may occur if (“Start/Stop” button) is accidentally pressed and the machine starts sewing.

cLower the presser foot lever.

1

aPresser foot lever

dPlace fabric or paper under the presser foot to cover the hole in the needle plate.

Note

zBefore replacing the needle, cover the hole in the needle plate with fabric or paper to prevent the needle from falling into the machine.

40