Brother CPS5XVY operation manual bIt fits into the grooves, and then loosely tie it, Memo

————————————————————————————————————————————————————

■Changing the density of the stitching Adjust the stitch length.

•For details, refer to “Adjusting the stitch length” (page 57).

•If the fabric does not feed (for example, if it is too thick), decrease the density of the stitching.

■Changing the stitch width Adjust the stitch width.

•For details, refer to “Adjusting the stitch width” (page 56).

Memo

zBefore sewing buttonholes, check the stitch length and width by sewing a trial buttonhole on a scrap piece of fabric.

■Sewing buttonholes on stretch fabrics

When sewing buttonholes on stretch fabrics, use a gimp thread.

aHook the gimp thread onto the part of buttonhole foot “A” shown in the illustration.

bIt fits into the grooves, and then loosely tie it. 3

cAttach buttonhole foot “A”.

•For details, refer to “Replacing the presser foot” (page 42).

dSelect stitch 52 or 53.

eAdjust the stitch width to the thickness of the gimp thread.

fLower the presser foot lever and the buttonhole lever, and then start sewing.

gWhen sewing is finished, gently pull the gimp thread to remove any slack.

hUse a handsewing needle to pull the gimp thread to the wrong side of the fabric, and then tie it.

Buttonhole Stitching/Button Sewing 91