Brother DCP-8085DN manual 83

Error Message	Cause	Action
Fuser Error	The temperature of fuser unit	Turn the power switch off, wait a few
	does not rise at a specified	seconds, and then turn it on again. Leave the
	temperature within specified time.	machine for 15 minutes with the power on.
	The fuser unit is too hot.
Jam Duplex	The paper is jammed in the	(See Paper jams on page 80.)
	duplex tray.
Jam Rear	The paper is jammed in the back	(See Paper jams on page 80.)
	of the machine.
Jam Inside	The paper is jammed inside the	(See Paper jams on page 80.)
	machine.
Jam MP Tray	The paper is jammed in the MP	(See Paper jams on page 80.)
	tray of the machine.
Jam Tray 1	The paper is jammed in the paper	(See Paper jams on page 80.)
Jam Tray 2	tray of the machine.
No Paper	The machine is out of paper or	Do one of the following:
	paper is not correctly loaded in	„ Refill the paper in the paper tray or MP
	the paper tray.
		tray.
		„ Remove the paper and load it again.
No Toner	The toner cartridge or the drum	Re-install the toner cartridge or the drum unit
	unit and toner cartridge assembly	and toner cartridge assembly.
	is not installed correctly.
No Tray	The paper tray is not completely	Close the paper tray properly.
	closed.
Out of Memory	The machine’s memory is full.	Copy operation in progress
		Do one of the following:
		„ Press Start to copy the scanned pages.
		„ Press Stop/Exit and wait until the other
		operations in progress finish, and then try
		again.
		„ Clear the data from the memory. (See
		Out of memory message on page 39.)
		Print operation in process
		Reduce print resolution. (See Advanced tab
		in the Software User’s Guide on the CD-
		ROM.)
Print Unable XX	The machine has a mechanical	Disconnect the machine from the power for
	problem.	several minutes, then reconnect it.
Protected Device	The protect switch of the USB	Turn off the protect switch of the USB Flash
	Flash memory drive is on.	memory drive.

76