USER’S GUIDE
2.Unscrew the four screws securing the rear plate of the main controller board and pull out the main controller board.
Fig. 4-4 Removing the Main Controller Board
3. Unpack the SIMM and hold it by its edge.
!Caution
Do not touch the memory chips and the surface of the main controller board. If static electricity collects, it may damage these electrical parts.
4. Install the SIMM into the slot and push gently until it clicks into place.
Fig. 4-5 Install the SIMM
5.Install the main controller board into the printer by sliding it into the guide rails.
6.Secure the main controller board with the four screws.
7.Reconnect the interface cable (printer cable) from your computer. Plug the power cord into the AC outlet and turn on the power switch.
8.To check whether the SIMM was installed correctly, you may perform a Test Print “Print Configuration” which will print the current memory size.
CHAPTER 4
