Others

Problem

The printer cannot print. “There was an error writing to LPT1: (or BRUSB) for the printer.” error message occurs on your PC.

Recommendation

∙Check that the printer cable is not damaged or broken.

∙Make sure the correct printer is selected if you have an interface switching device.

For printing with the Serial Interface (For HL-1250 Only)

Problem

Recommendation

Unable to print from

∙ If you use the serial interface, make sure that the slide switch of

application software.

the serial interface is in the correct serial position and the

 

interface settings are correctly set up with the DIP switches.

For DOS users (For HL-1240/1250 Only)

Problem

 

Recommendation

Unable to print from

 

∙ Check that the DOS application software interface settings

application software.

 

match that of your printer : for example, if you are using a

 

 

parallel printer cable, you would most likely set your DOS

 

 

software printer port to LPT1.

 

 

∙ Check if the printer has any printer alarms.

 

 

∙ Check if the appropriate printer is selected in your application

 

 

software.

(For HL-1250 Only)

∙ If the serial interface is used, make sure that the RS-232C serial interface is selected with the slide switch. Make sure that the interface settings are correctly set up with the proper DIP switches. Make sure the serial parameters of baud rates, parity and stop bits match between your application software and the printer.

4-16