Test Print Mode
The printer has the following test print modes. Follow these steps:
1.
2.
3.
Make sure that the front cover is closed.
Hold down the control panel button and turn on the power switch. Keep the button depressed until the Drum LED comes on.
The Drum LED illuminates to indicate that the printer is in the test print mode.
Release and then press the button again to execute the test print or hold down the button to select another option as shown in the table below and release the button to execute the selected option.
LED Lit | Choice | Function |
Drum | Test sample page | The printer prints a test sample page. |
|
| The printer returns to the ready status after |
|
| printing. |
Ready | Print Config & | The printer prints the current configuration |
| Print Fonts I | of the printer and a list of the internal fonts. |
|
| The printer returns to the ready status after |
|
| printing. |
Alarm | Factory Reset | The printer is restored to the factory setting |
|
| and permanent fonts and macros are |
|
| cleared. |
|
| The printer returns to the ready status after |
|
| printing. |
Data | Hex Dump Print | The printer can print data as hexadecimal |
|
| values so that you can check data errors and |
|
| problems. To exit from this mode, you |
|
| have to turn off the printer. |
|
|
|