Brother PT-9400 manual New Block Code +

New Block

Functions

Ch. 3 Functions

2Press the key for the desired character.

NOTE

☞ To display capital letters, hold down Shift(or

press Caps to turn on Caps mode) before press- ing a letter key.

☞To turn off the Alt mode without adding a char-

			Cancel	(or	Alt
acter to the text, press						) at any time
			Back- Half
Caps Alt Template Zoom			ground	Cutter
		éèêee					36mm	1 1/2"
	ë						24mm	1"
uffl			ë				18mm	3/4"
							12mm	1/2"
							9mm	3/8"
							6mm	1/4"
		A
		Style	Italic	Vertical

3Press or until the desired accented character or symbol is highlighted.

Back-	Half
Caps Alt Template Zoom ground	Cutter
		36mm	1 1/2"

ë	é	èêee		24mm	1"
uffl			é	18mm	3/4"
				12mm	1/2"
				9mm	3/8"

Enter ( New Block )

To create a new line and move the cursor to the

beginning of it, press once you have fin- ished entering a line of text. .

NOTE

A single block of text can only contain the maxi- mum number of lines shown in the table below. If the block already contains the maximum number of

lines when you press			New Block		, the error message
“LINE LIMIT” will appear.
	Tape widths			Maximum number of
				lines that can be entered
	1/4”	(6 mm)			2
	3/8”	(9 mm)			3
	1/2”	(12 mm)			4
	3/4”	(18 mm)			6
	1”	(24 mm)			8
	1 1/2”	(36 mm)			10
New Block ( Code +			New Block		)

To change the number of lines in a section of the label, create a new block by holding down

Code

and pressing New Block .

NOTE

☞A single label can only contain a maximum of

five blocks. If five blocks already exist when

6mm 1/4"

A

Code

is held down and is pressed, the

New Block

Style	Italic Vertical
4 Press New Block	. The selected character is

added to the text and Alt mode turns off.

NOTE

To enter a series of characters in Alt mode, hold

	Code
down	before pressing New Block . Then, con-

tinue adding characters by selecting them as explained in steps 2 and 3, and holding down

Code

while pressing New Block . Press just New Block

after selecting the last character in the series.

error message “MAX 5 BLOCKS” will appear.

☞To split a text block into two so that the charac- ter on the right of the cursor is at the beginning of the second block, position the cursor in the

Code

middle of the block, and then hold down

and press New Block .

16