Brother Sewing Machines operation manual Reinforcement Stitching, Memo

————————————————————————————————————————————————————

cSelect stitch 52 .

•For details, refer to “Selecting stitching” (page 67).

dAttach buttonhole foot “A”.

•For details, refer to “Replacing the presser foot” (page 41).

ePass the upper thread down through the hole in the presser foot, and then pull it under the presser foot, as shown.

fWith the opening of the pocket toward you, position the fabric so that the needle drops 2 mm (1/16 inch) in front of the pocket opening, and then lower the presser foot lever.

a

a2 mm (1/16 inch)

Note

zWhen lowering the presser foot, do not push in the front of the presser foot, otherwise the bar tack will not be sewn with the correct size.

gPullpossible.down the buttonhole lever as far as

a

aButtonhole lever

The buttonhole lever is positioned behind the bracket on the buttonhole foot.

1

3

2

aButtonhole lever

bBracket

hGently hold the end of the upper thread in your left hand, and then start sewing.

XOnce sewing is completed, the machine automatically sews reinforcement stitches, then stops.

iCut the threads, raise the presser foot lever, and then remove the fabric.

jRaiseposition.the buttonhole lever to its original

Memo

zIf the fabric does not feed, for example, because it is too thick, increase the stitch length. For details, refer to “Adjusting the stitch length” (page 59).

Reinforcement Stitching 101