GUIDE SPECIFICATIONS continued
K.Electrical Requirements:
All unit power wiring shall enter the unit cabinet at a single location.
L.Motors:
1.Compressor motors shall be of the
2.All fan motors shall have permanently lubricated bear- ings, and inherent, automatic reset, thermal overload protection.
3.Condenser fan motor shall be totally enclosed.
M.Grille:
1.Louvered Grille:
Louvered grille shall be
N.Duct Conversion:
Shall be available with the use of included duct covers. O. Special Features:
1.ICM Indoor Blower FIOP:
Integral control motor shall be a factory installed option for optimizing comfort levels in all operating modes and increasing system efficiency.
2.Coil Options:
Shall include
3.Economizer:
a.Economizer controls capable of providing free cool- ing using outside air.
b.Equipped with low leakage dampers not to exceed 3% leakage, at 1.0 in. wg pressure differential.
c.Spring return motor shuts off outdoor damper on power failure.
4.Flat Roof Curb:
Curbs shall have seal strip and a wood nailer for flash- ing and shall be installed per manufacturer’s instruc- tions.
5.Manual Outdoor Air Damper:
Package shall consist of damper, birdscreen, and rain- hood which can be preset to admit outdoor air for year- round ventilation.
6.Thermostat:
To provide for
7.
Shall be complete with all required hardware to convert to liquid propane (LP) operation.
8.Low Ambient Package:
Shall consist of a
9.Filter Rack Kit:
Shall provide filter mounting for downflow applications.
10.
Shall have the ability to convert the supply and return openings from rectangular to round.
11.Compressor Protection (Time Guard® II Kit)
12.Crankcase Heater:
Shall provide
13.High Altitude Kit:
Shall consist of natural gas orifices to compensate for gas heat operation at 2001 to 6000 ft above sea level.
14.Low NOx (Natural Gas only) option:
Shall provide NOx reduction to values below 40 nano- grams/joule to meet California emission requirements.
15.Compressor Hard Start Kit:
Shall provide additional starting torque for
16.Rigging kit includes lifting brackets which are inserted into the basepan handholds to rig unit for rooftop appli- cations.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
UNIT MUST BE INSTALLED IN ACCORDANCE
WITH INSTALLATION INSTRUCTIONS
Cancels: PDS 583B.24.2
Form PDS 583B.24.3
© 2001 Bryant Heating & Cooling Systems, 7310 W. Morris St., Indpls., IN 46231 | PRINTED IN U.S.A. | Catalog No. |