To erase a registration code

Press the QUICKDIAL button.

Press the CHANNEL SEEKER button.

Press the button four times.

Press the QUICKDIAL button. You will hear a confirmation beep. The old registration code is now erased and you can re- register your additional handset following the procedure below.

To re-register an additional handset

If necessary, you can re-register your additional handset by simply following the steps described in ‘To register an additional handsetÕ on the previous page.

Before re-registering, the old registration code must first be erased.

To check that your additional handset is registered correctly

Lift the additional handset.

Press the TALK button.

The IN USE light on the base unit will come on.

Listen for the dial tone.

If you do not hear a dial tone, your additional handset is either out of range of your Freestyle 1200, the Freestyle 1200 phone line cord is not plugged in, it has not been

Freestyle 90/130/1200 Additional Handsets

registered properly or you may have purchased the wrong handset

-check that your handset has item code: 871267. This can be found on the side of your giftbox.

Setting the handset number

Each additional handset must be assigned an identity number (2, 3 or 4). Your Freestyle 1200 handset is already numbered as HANDSET 1. Additional handsets can then be numbered as they are added.

Your Freestyle additional handset is pre-set to handset number 2.

To set a handset identity number

Press the QUICKDIAL button.

Press the SECRECY button.

Enter the identification number (2-4) using the keypad.

When you have entered the number, press the QUICKDIAL button.

You will hear a beep confirming that the new number has been stored.

Make a note of the identification number by writing it on the handset’s directory label.

35

Page 37
Image 37
BT 1200 manual Setting the handset number