Check to see that quick draw handle has moved to the handle engaged position by rolling quick draw bucket or attachment back and then raising loader boom to hood height.
NOTE: Quick draw handle must be located in the handle engaged position. Refer to Figure 4 below and to Figures 5 and 6 page 28.
Figure 4
Check that quick draw bucket or attachment is securely attached to quick draw latch attach by rais- ing loader boom 3 to 4 feet, dumping quick draw bucket or attachment against stops, and checking to be sure quick draw bucket or attachment does not roll out of quick draw latch attach. Refer to Figure 5.
Figure 5
WARNING 
A QUICK DRAW BUCKET OR ATTACHMENT THAT IS NOT SECURELY LOCKED INTO QUICK DRAW LATCH ATTACH COULD COME OFF DURING LOADER OPERATION CAUSING SERIOUS INJURY OR DEATH.
Inspect quick draw attaching areas to verify that quick draw pins have engaged quick draw bucket or attachment fully. Refer to Figure 6.
Figure 6
(1)Quick draw pin.
(2)Quick draw pin bushing.
(3)Quick draw bucket or attachment engaging bar.
If installing an attachment utilizing a third cylinder hydraulic circuit, connect loader hose quick couplers to attachment quick couplers.
30
