11. BUCKET ATTACHMENT
QUICK DRAW BUCKET
IMPORTANT: Refer to pages 29 & 30 for instruc- tions concerning Installing Attachment to Quick Draw Latch Attach.
IMPORTANT: Refer to page 31 for instructions concerning Removing Attachment from Quick Draw Latch Attach.
Quick draw buckets are available as follows.
72 inch, 84 inch, and 96 inch wide for Bush Hog 3860 Loaders.
These buckets utilize a replaceable
Heavy duty/high capacity quick draw buckets are available as follows.
72 inch, 84 inch, 96 inch, and 102 inch wide for Bush Hog 3860 Loaders.
These buckets utilize a replaceable
These buckets are equipped with a clevis mounting point for lifting. Refer to Figure 1.
CAUTION 
NEVER LIFT ANY LOAD FROM ANY POINT OF THE LOADER WITH A CHAIN, ROPE, OR CABLE UNLESS LOADER IS EQUIPPED WITH A BUSH HOG FACTORY APPROVED ATTACHMENT WHICH WAS DESIGNED AND BUILT FOR THIS TYPE OF LIFTING. ALWAYS FOLLOW LIFTING INSTRUCTIONS INCLUDED WITH THIS ATTACHMENT.
NEVER TOW FROM ANY POINT OF THE LOADER WITH A CHAIN, ROPE, OR CABLE. DOING SO COULD CAUSE A ROLL OVER OR SERIOUS DAMAGE TO THE LOADER.
MAXIMUM LOAD LIMIT ON BUSH HOG CLEVIS AND CLEVIS MOUNTING POINT IS 6500 POUNDS. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD CAUSE DAMAGE TO LOADER AND/OR INJURY TO OPERATOR.
Figure 1
(1)Bucket, heavy duty, high capacity.
(2)Clevis mounting point.
(3)Clevis (use only Factory approved clevis).
(4)Clevis pin.
(5)Cotter Pin.
SINGLE TINE KIT
Single tine kits are available for mounting on pre- punched buckets as follows. Each single tine kit includes one tine and attaching hardware.
72 inch quick draw buckets are punched for eight (8) single tine kits.
84 inch quick draw buckets are punched for ten (10) single tine kits.
96 inch quick draw buckets are punched for ten (10) single tine kits.
32
