12. SUPER PENETRATOR BALE PROBE ATTACHMENT
IMPORTANT: It is not recommended that loader be detached from tractor with bale probe attached. Loaders will park safely, however, bale probe could be damaged during parking. Always detach loader with bucket or other Factory approved attachment attached.
CAUTION 
WHEN TRANSPORTING A ROUND BALE, TILT THE BALE PROBE SLIGHTLY BACK FROM LEVEL AND CARRY THE LOAD IN A LOW POSITION.
APPROACH, PENETRATE AND TRANS- PORT ROUND BALES AT SLOW SPEED.
DO NOT LIFT ANYTHING WITH PROBE EXCEPT ROUND BALES.
NEVER RAISE ROUND BALE TO FULL HEIGHT WITH BALE PROBE ROLLED BACK AS SERIOUS INJURY OR DEATH COULD OCCUR.
TO PREVENT BODILY INJURY, PARK AND STORE BALE PROBE WITH POINTS POINTED AGAINST BALE, BUILDING OR OTHER STABLE OBJECT.
IMPORTANT!
THIS SPEAR IS A HIGH STRENGTH ALLOY- DROP FORGED STEEL AND SHOULD NOT BE WELDED OR HEAT TREATED.
IMPORTANT: Maximum load limit on super pene- trator bale probe is 2,200 pounds.
INSTALLATION INSTRUCTIONS
IMPORTANT: Refer to pages 29 & 30 for instruc- tions concerning Installing Attachment to Quick Draw Latch Attach.
IMPORTANT: Refer to page 31 for instructions concerning Removing Attachment from Quick Draw Latch Attach.
Install bale probe into tapered sleeve and secure with 28mm nut. Torque super penetrator nut to 515 ft. lb. Refer to Figure 1. Failure to follow these instructions could cause damage to probe and void your warranty.
Figure 1
(1)Super penetrator bale probe.
(2)Tapered sleeve.
(3)Nut, 28mm. Torque super penetrator nut to 515 ft. lb.
2,200 lb Capacity
OPERATING INSTRUCTIONS
With bale probe attachment level with ground, slowly probe bale slightly above center. Refer to Figure 2.
Figure 2
With all three bale probes completely engaged into bale, tilt the bale probe attachment slightly back from level and transport the load in a low position.
33
