Switch Administration | Upgrading and Changing Software |
Changing the Default Boot Load Image
Continuing with the example above, perform the following steps to set boot load image 0 back to being the default.
1.Reboot the SmartCell 6A000.
2.When the following message appears
“Preparing to run Default Primary Image: 1
Enter 0 or 1 to override and force one of these primary image sectors to run:”
press the zero (0) key. The SmartCell 6A000 loads boot load image 0.
3.Use the chpi command to make boot load image 0 the default.
=>chpi 0
Old Default Primary Image Number: 1
Erasing Sector in Primary Flash sector4
Programming control/stat info into Primary Flash sector4
New Default Primary Image Number: 0
=>
4.Reboot the SmartCell 6A000. Boot load image 0 is now used as the default image.
Preparing to run Default Primary Image: 0
Enter 0 or 1 to override and force one of these primary image sectors to run:
4.7.4Upgrading POST Diagnostic Software
1.Set up the TFTP/Bootp server software on a workstation.
2.Connect both the TFTP/Bootp server and the SmartCell 6A000 to your Ethernet network. Make sure that the TFTP/Bootp server can be reached by the SmartCell 6A000 Ethernet interface.
3.Connect a dumb terminal (or PC running terminal emulation software) to the SmartCell 6A000 Terminal port.
4.Copy the SmartCell 6A000 diagnostic software image into the appropriate location on the TFTP/Bootp server. (In this example, the software is located at c:\tftpboot\images\post.ima.)
5.Set up the TFTP/Bootp server tables (or equivalent file) with:
-SmartCell 6A000 MAC address
-IP address of the SmartCell 6A000 Ethernet interface
-path to the POST file on the TFTP/Bootp server
6.From the terminal connection, enter the reboot command.
7.When the following message appears,
“Press any key to exit to boot load prompt.”
stop the countdown by pressing any key. The boot load prompt (=>) appears on the terminal screen.
8.Enter the df P command. The SmartCell 6A000 contacts the TFTP/Bootp server and downloads the diagnostic software into flash RAM.
=>df p
You've requested a POST Software download
Are you sure?(Y/N)y
Initializing ethernet...
Starting Bootp...
Boot file: c:\tftpboot\images\post.ima
Using TFTP to get bootfile "c:\tftpboot\images\post.ima" .
............................................................................
SmartCell 6A000 User Guide
