LLDP Agent
Issue 1 July 2006 149
LLDP Agent CLI Commands
The following table contains a list of the CLI commands for the LLDP Agent feature. The rules of
syntax and output examples are all set out in detail in the Reference Guide for the Avaya C360
Converged Stackable Switch, 10-300506.
In order to... Use the following command...
Enable or disable the LLDP
application globally (per stack). set lldp system-control
Configure the interval at which
the device transmits LLDP
frames
set lldp tx-interval
Set the TxHoldMultiplier set lldp tx-hold-multiplier
Set the TxDelay set lldp tx-delay
Set the reinitDelay lldp re-init-delay
Display the global LLDP
configuration show lldp config
Change the administrative lldp
port status set port lldp
Enable or disable the
transmission of the optional TLVs
on a per-port basis
set port lldp tlv
Display port-level lldp
configuration. show port lldp config
Display the VLAN-Name TLVs
that are being transmitted on a
specific port
show port lldp vlan-name config
Display the LLDP information
received on each port show lldp