Avaya C360 Layer 3 Features
170 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Static Routing Configuration CLI CommandsRoute Preferences
The routing table may contain routes from different sources. Routes to a certain destination may
be learned independently from RIP and from OSPF, and at the same time, a static route can
also be configured to the same destination. While metrics are used to choose between routes of
the same protocol, protocol preferences are used to choose between routes of different
protocols.
The preferences only apply to routes for the same destination IP address and mask. They do
not override the longest-match choice. For example, a high-preference static default route will
not be preferred over a RIP route to the subnet of the destination.
In order to... Use the following command...
Establish a static route ip route
Remove a static route no ip route
Set the maximum number of
route entries in the routing table ip max-route-entries
Set the maximum number of
route entries in the routing table
to the default value
no ip max-route-entries
Define a default gateway
(router) ip default-gateway
Remove the default gateway
(router) no ip default-gateway
Delete all the dynamic routing
entries from the Routing Table clear ip route
Display information about the IP
unicast routing table show ip route
Display a routing table for a
destination address show ip route best-match
Display the static routes show ip route static
Display the number of routes
known to the switch show ip route summary