Canon C360 - page 203

Troubleshooting the Installation
Issue 1 July 2006 203
Stacking not functioning
Tip:
Tip: Use the stack health command to display the status
of the stack. See Stack Healthon page 204 for further
information.
●X360-STK modules
not inserted correctly
(LEDs on stacking
module do not light)
●Check that modules are installed
correctly
●Octaplane cables not
installed correctly
(LEDs on stacking
module do not light)
●Check that the cables are
inserted correctly
●Check that there are no
cross-corrections
●The pins on the
Octaplane cable are
bent or broken
●Replace the cable
●The socket on the
stacking module is
damaged
●Replace the stacking module
●NVRAM INIT jumper is
bridged
●Remove the stacking module and
then unbridge the jumper.
Table35: Troubleshooting 3 of 3
Problem/Cause Suggested Solution
3 of 3