a: Fully Automatic Wireless Flash Shooting
3 Check the transmission channel. If the channels of the master unit and slave unit are different, set them to the same number (p.78).
4
5
Position the camera and the flash.
Position them within the range shown on page 76.
Set the flash mode to <a>.
Press the <E> button on the master unit and set the flash mode to <a>.
The slave unit is set automatically to <a> during shooting via the control from the master unit.
To also fire the master unit, set the master flash firing to ON (p.79).
6 Check that the flash is ready.
Check that the master
When the slave flash is ready, the AF- assist beam firing area blinks in intervals of 1 second.
7 Check the operation.
Press the master unit’s test flash button.
X The slave unit flashes. If the slave unit does not fire, check that it is placed within the operation range.
8 Take the picture.
Set the camera and take the picture, in the same way as with normal flash shooting.
XIf a standard flash exposure was obtained, the flash exposure confirmation lamp lights for 3 sec.
82
