[g)

English

• Regions

of

Use and Restrictions for the 600EX-RT/ST-E3-RT

• The Speedlite 600EX-RT/ST-E3-RT complies with local radio wave regulations
in
the following areas.
Please do not use this product
in
areas it was not designed
for.
Brunei, Sri Lanka, China, Taiwan, Hong Kong, India, Japan, Macao, Philippines, Singapore, Vietnam,
Canada, United States, Cayman Islands, Colombia, Costa Rica, Ecuador,
El
Salvador, Guatemala,
Panama, Peru, Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Romania, Russia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
United Kingdom, Australia, New Zealand, Lebanon, Saudi Arabia, Turkey
• The following actions may be punishable under law. Disassembling or modifying the transmitter, or removing
the certification label on
it.
•
Do
not use the transmitter near other devices that emit radio waves, such as medical equipment or
electronic devices. The transmitter may interfere with operation
of
these devices.
Complies
with
IDA
Standards
0800671
FCC/IC NOTICE
This device complies with Part 15
of
the FCC Rules and RSS-Gen
of
IC
Rules.
Operation
is
subject to the following two conditions;
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation
of
this device.
Note: This equipment has been tested and found to comply with the limits for class B digital device,
pursuant to Part 15
of
the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
in
a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used
in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in
a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more
of
the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into
an
outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated
in
conjunction with any other antenna or transmitter
except Canon accessories supplied or designated for this product.
Do
not make any changes or modifications to the equipment unless otherwise specified
in
the manual. If
such changes or modifications should be made, you could be required to stop operation
of
the equipment.
This equipment complies with FCC/IC radiation exposure limits set forth for
an
uncontrolled environment
and meets the FCC radio frequency (RF) Exposure Guidelines
in
Supplement C to OET65 and RSS-1 02
of the
IC
radio frequency (RF) Exposure rules. This equipment has very low levels of
RF
energy that are
deemed to comply without testing
of
specific absorption ratio (SAR).
Canadian Radio Interference Regulations
The Class B digital apparatus complies with Canadian ICES-003.