58
a: Fully Automatic Wireless Flash Shooting
5Set the flash mode to <a>.
Press the <E> button on the
master unit and set the flash mode to
<a>.
The slave unit is set automatically to
<a> during shooting via the
control from the master unit.
To also fire the master unit, set the
master flash firing to ON (p.55).
6Check the transmission status
and that the flash is ready.
Check that the <D> lamp is lit in
green.
When the slave flash is ready, the
AF-assist beam emitter blinks at
1-second intervals.
Check that the <Q> slave flash-ready
icon is lit on the master unit’s LCD
panel.
When the recycling of all the flash
units is completed, the master unit’s
flash-ready lamp lights.
7Check the operation.
Press the master unit’s test flash
button.
XThe slave unit flashes. If the slave
unit does not fire, check that it is
placed within the operation range.
8Take the picture.
Set the camera and take the picture,
in the same way as with normal flash
shooting.
XIf a standard flash exposure was
obtained, the flash exposure
confirmation lamp lights for 3 sec.