Chapter 1 15
Before Printing
(26)Power Connector
This is the connector used to connect the provided power cord.
(27)Rear Cover
Open when clearing jammed paper.
(28)USB Connector (for computer)
This is the connector used to connect the machine to a computer using a USB cable.
Operation Panel Name and Functions
(1) [ON/OFF]
Turns the machine ON and OFF. Before turning ON the machine, make sure the
Document Cover is closed.
(2) Alarm Lamp
Lights or flashes orange, when an error occurs, or when paper or ink has run out.
(3) Cassette Lamp
Lit when the Cassette is selected.
(4) Auto Sheet Feeder Lamp
Lit when the Auto Sheet Feeder is selected.
(5) [Feed Switch]
Selects the paper source. Press this toggle switch to change the paper source between
the Auto Sheet Feeder and Cassette.
Important While the machine is printing from or scanning images to the computer, or
the computer is in the sleep mode or standby mode, do not disconnect
and connect the USB cable.
Note zFor information on how to install the Print Head and ink tanks, refer to
theEasy Setup Instructions.
Ink Tank Lamps
zYou can check the status of each ink tank according to the way its
lamp flashes.
On: The machine is ready to print.
Slow flashing (about three seconds): Ink is low. Prepare a new ink
tank. For details, see “Getting the Ink Level Information” on page97.
Fast flashing (about one second): Ink tank is empty, or the machine is
not ready due to an error.
Off: Make sure all the ink tanks are installed properly. If an Ink Tank
Lamp remains unlit even after reinstalling ink tanks, an error has
occurred and the machine is not ready to print.
(3) (5) (8) (11)(10)(9)
(7)(6)
(4)(2)(1)
(12) (13) (14) (15) (17)(16) (18) (19) (20) (21)