Chapter 12 139
Troubleshooting
Slow scanning speed“There is not enough memory.” message is displayedScanned image not displayed properly
Cause Action
Resolution is set higher than
necessary.
To view the image on a monitor, set the output resolution to 75 dpi. To
print, set the output resolution to a value such as 300 dpi.
Image correction features such as
dust and scratch reduction, fading
correction, and descreening are
enabled in ScanGear MP.
Set [Reduce Dust and Scratches], [Fading Correction], and [Descreen] to
[OFF] in the [Image Settings] section of the Advanced Mode of ScanGear
MP.
Cause Action
There is not enough memory to
continue scanning.
Exit any application software that are running, and try to run this software
again.
Cause Action
Scanned image prints out enlarged
(reduced).
Set the printing size in the application software.
Example: ArcSoft PhotoStudio
1. With the image in the selected state, click the [File] menu and select
[Print].
2. Move the print size slider left or right in the Print dialog to adjust the
printing size. The preview image to the left will change size accordingly.
Scanned image enlarged (reduced)
on the computer monitor.
zChange the display setting in the application software.
zImages opened in [Paint] or [Imaging] may be displayed in full size and
you may not be able to reduce its display size. Open the image in an
application software supplied with the scanner instead. Refer to the on-
screen manual for each application software for the detailed
procedures.
zChange the resolution setting in the scanner driver and rescan. The
higher the resolution, the larger the resulting image will be.
zSome application software do not display clear images at small image
display settings. Set the scale to 100%.