2 Prepare to load paper. | (1) | |
(1) Open the Sheet Feeder Cover and pull out the | (A) | |
Paper Support. | ||
| ||
Put your finger in the rounded indent of the |
| |
Paper Support and pull it out until it stops. |
|
(2) Open the Paper Output Tray.
Put your finger in the center of the top of the Paper Output Tray and open it gently.
(3) Open the Output Tray Extension.
(4)Press the Paper Feed Switch so that the
Rear Tray lamp (A) lights. | (4) | (3) (2) |
Note
You can also select the paper source with the printer driver.
For details, refer to the PC Printing Guide
3 Load the paper. | (B) | (3) | (1) (2) |
(1)Load the paper in the Rear Tray with the print side facing UP.
(2) Align the paper stack against the Cover Guide on the right side of the Paper Support.
Note
Make sure that the Cover Guide is set upright when you load paper in the Rear Tray.
(3) Pinch the Paper Guide and slide it against the left side of the paper stack.
Important
Do not slide the Paper Guide too hard. The paper may not be fed properly.
Do not load higher than the Load Limit
Mark (B).
4 Specify the page size and media type settings according to the loaded paper.
Note
zWhen performing copy direct printing without using a computer, select the size and type of the loaded paper in Page size and Media type in each mode. For details on settings in each mode, see “Setting Items” on page 25 and page 30.
zWhen using the machine connected to a computer, select the size and type of the loaded paper in Page Size (or Paper Size) and Media Type in the printer driver.
For details on printer driver settings, see “Printing with Windows” on page 40 or “Printing with Macintosh” on page 41.
Before Using the Machine | 17 |