Capresso Impressa J5 warranty Please, Do, Factory Settings, chapter, CUP ILLUMINATION .13a

•Never fill anything other than coffee beans into the bean container (no chocolate, rice, nuts, spices, etc.)

•Never fill anything but fresh, cold clean water into the water container, except when decalcifying (chapter 18.3).

•Never use mineral or carbonated water. You can use tap water, bottled water, spring water, distilled water and reverse osmosis water.

•Never repair or open the machine yourself. All repairs should be performed only by an authorized service center.

•Do not place the machine on a surface which is sensitive to hot or cold water and steam.

PLEASE, DO...

•Fill water tank with fresh, cold water only.

•Remove any foreign particles (small stones) from coffee beans.

•Let frozen beans thaw 3 to 4 hours before pouring them into the bean container.

5. FACTORY SETTINGS

Each machine leaves the factory with the following pre-sets:

•Steam Button.........20 seconds

•Hot Water Button ...6 oz., temp. HOT

•1 Espresso Button....1.5 oz., temp. HIGH, coffee strength: STRONG

•2 Espressi Button .....1.5 oz. (per cup!), temp. HIGH

•1 Coffee Button ........5.0 oz., temp. HIGH, coffee strength: NORMAL

•2 Coffee Button .....5.0 oz.(per cup), temp. HIGH

Please note: You can change all above pre-sets (chapter 17.2). You can also override the strengths and the cup size before/ during actual brewing. Overriding will not change the preset values (chapter 11.1).

Other functions are set as follows (to change functions refer to
listed chapters.)
		chapter
Filter (Clearyl)	– not installed	15.1
Hardness Level	10º dH	16
Auto-Off	2 Hours	17.6
Grinder Fineness	Middle position ....	7
Energy Saving	– not set	17.3
Time format	AM/PM	17.8
Volume format	in ounces OZ	17.8
Language	English	17.9
Time	not set	17.4
Unit On (Auto-On)	not set	17.5

CUP ILLUMINATION (Fig. 1.13a)

The cup illumination adds a dramatic touch to brewing coffee. Providing the main power switch is on, you can activate the cup illumination for 1 minute by pressing any button.

6.PREPARING THE J5 FOR THE FIRST TIME Make sure

• all accessories, literature, caution leaflets etc. are removed from the machine, the water tank, and the bean container.

• the Clearyl Water Filter is NOT installed!

• the machine sits on a flat, even surface and the drawer, tray and used coffee container are inserted (Fig 2).

• machine is NOT placed on a surface which is sensitive to heat, water and steam.

Plug-in machine.

12.