Capresso Impressa J5 warranty Extremely Hot Coffee, Coffee with Milk, Brewing Coffee And Espresso

Extremely Hot Coffee:

If you like your coffee even hotter you can inject steam. This will make the crema disappear.

•Slip on the Dual Frother Plus (Fig. 18)

•Push the Steam button (Fig. 3). The display shows HEATING. After a few seconds the display shows READY.

•Immerse the tip of the Dual Frother into your cup of coffee and push the Steam button again. Hot steam is injected.

•Push any button to stop the steam injection.

CAUTION: If you steam the coffee too long it will begin to boil and possibly splash from your cup.

Coffee with Milk:

If you normally add cold milk to your coffee we recommend to pre-warm your milk. Proceed as follows:

•First add cold milk to your pre-warmed cup.

•Use the Dual Frother to steam the milk (Fig. 18, 19, 20)

•Push the Steam button: HEATING. It will take a few seconds for the system to be ready for steam.

•When the display shows READY, immerse the tip of the Dual Frother into the milk and push the Steam Button. STEAM. Let the hot steam warm up the milk for a few seconds.

•Then push the steam button again, to stop.

•Now place the cup under the coffee spouts and add your coffee.

11. BREWING COFFEE AND ESPRESSO

(1 ESPRESSO, 2 ESPRESSI, 1 COFFEE, 2 COFFEES)

•Place one or two cups underneath Dual Coffee Spouts and push the desired button.

The Impressa J5 will grind, tamp and then brew the coffee. It

uses a 2-step brewing process (Pre-Brew Aroma System). First, it moistens the ground coffee (pre-brew phase), pauses for a few seconds, and then starts the brewing process. The display will show the name of the button you pushed, e.g.

1 ESPRESSO and then the strength, e.g. STRONG and then

1 ESPRESSO again. The brewing process stops automatically as soon as the programmed volume of coffee is produced. Very Important: After the brewing stops, the J5 will discard the used coffee. Please do not pull out the drawer (Fig. 1.11) during this time. It can seriously damage the machine. There is no need to pull out the drawer unless you see the message EMPTY GROUNDS, see chapter 21.

When the display shows READY you can brew the next cup of coffee.

Please note: You can always stop the brewing process by pushing the Rotary Dial or any of the beverage buttons. This will not affect the programmed values.

11.1OVERRIDING STRENGTH AND CUP SIZE DURING BREWING.

With the J5’s override feature you are always able to change certain settings just before brewing without affecting the pre-set values. This is a great feature if you desire a different kind of coffee which is not programmed. (For changing programmed values see chapter 17.2).

•For the two single-cup coffee buttons you can override the strength and the coffee volume.

•For the two double-cup coffee buttons you can override the coffee volume (those two buttons will always brew in the XSTRONG setting).

15.