FILL BEANS.
The bean container is (almost) empty. Add beans to the bean container.
FILL WATER TANK.
The water tank is (almost) empty. Add water to the water tank.
CLOSE COVER.
The lid for the ground coffee funnel is open. Close the lid (Fig. 11)
NOT ENOUGH PRE-GROUND.
There is not enough
TOO HOT.
The J5 is too hot to perform a cleaning or decalcifying program. Use the hot water button and pump a few ounces of water through the system. Then try again.
CLEAN.
It’s time to run a tablet cleaning cycle. See chapter 18.1
DE-SCALE.
It’s time to run a decalcifying cycle. See chapter 18.3
22. TROUBLESHOOTING
A. COFFEE IS NOT HOT ENOUGH See chapter 10.
B. MILK IS NOT HOT ENOUGH See chapter 12.1.2.
C. NO COFFEE COMES OUT OF THE COFFEE SPOUT Reason: Beans in bean container are not feeding properly into
the grinder because they are stuck together.
Solution: Open the bean container safety cover (chapter 20.2) and stir beans.
When using very oily beans pour the beans onto a plate and let some of the sticky oils evaporate (this will not harm the aroma of the coffee).
Reason: You used ground coffee in the ground coffee funnel. The ground coffee was too fine.
Solution: Use ground coffee which is ground somewhat coarser.
Reason: No water is transported through the system.
Solution 1: Remove – if installed – the Clearyl water filter. Place a cup underneath the frother and push the Hot Water Button (Fig. 2). If water comes out, try to make coffee again.
Solution 2: Remove the water container and make sure that the connecting valve is free of any particles (like a coffee bean). Proceed as under “Solution 1”.
Reason: The ground coffee funnel is clogged; the internal brewing chamber is clogged.
Solution: Place a large cup underneath the coffee spouts and run one or two extra rinse cycles.
READY
•Push and hold the Rotary Button until the display shows
RINSE.
•Push the Rotary Button again. The display shows RINSING
and the machine pushes hot water through the coffee spouts and returns to READY.
•Repeat if necessary.
32.
