Carrier 50HE003-006, 50HJ004 installation instructions START-UP Checklist

50HE,HJ

START-UP CHECKLIST

(Remove and Store in Job File)

I. PRELIMINARY INFORMATION

MODEL NO.:	SERIAL NO.:
DATE:	TECHNICIAN:

II.PRE-START-UP (insert checkmark in box as each item is completed)

j VERIFY THAT JOBSITE VOLTAGE AGREES WITH VOLTAGE LISTED ON RATING PLATE j VERIFY THAT ALL PACKAGING MATERIALS HAVE BEEN REMOVED FROM UNIT

j REMOVE ALL SHIPPING HOLDDOWN BOLTS AND BRACKETS PER INSTALLATION INSTRUCTIONS j VERIFY THAT CONDENSATE CONNECTION IS INSTALLED PER INSTALLATION INSTRUCTIONS j CHECK ALL ELECTRICAL CONNECTIONS AND TERMINALS FOR TIGHTNESS

j CHECK GAS PIPING FOR LEAKS

j CHECK THAT RETURN (INDOOR) AIR FILTERS ARE CLEAN AND IN PLACE j VERIFY THAT UNIT INSTALLATION IS LEVEL

j CHECK FAN WHEELS AND PROPELLER FOR LOCATION IN HOUSING/ORIFICE AND SETSCREW TIGHTNESS

j CHECK TO ENSURE THAT ELECTRICAL WIRING IS NOT IN CONTACT WITH REFRIGERANT LINES OR SHARP METAL EDGES

j CHECK PULLEY ALIGNMENT AND BELT TENSION PER INSTALLATION INSTRUCTIONS

III.START-UP

ELECTRICAL

SUPPLY VOLTAGE	L1-L2	L2-L3	L3-L1
COMPRESSOR AMPS	L1	L2	L3
INDOOR-FAN AMPS	L1	L2	L3

TEMPERATURES
OUTDOOR-AIR TEMPERATURE	DB
RETURN-AIR TEMPERATURE	DB	WB
COOLING SUPPLY AIR	DB	WB
PRESSURES (Cooling Mode)
REFRIGERANT SUCTION	PSIG	F
REFRIGERANT DISCHARGE	PSIG	F

jVERIFY THAT 3-PHASE FAN MOTOR AND BLOWER ARE ROTATING IN CORRECT DIRECTION. IF THEY ARE NOT ROTATING IN CORRECT DIRECTION, LOCKING COLLAR MUST BE RE-TIGHTENED AFTER CORRECTING DIRECTION OF ROTATION

jVERIFY THAT 3-PHASE SCROLL COMPRESSOR IS ROTATING IN THE CORRECT DIRECTION j VERIFY REFRIGERANT CHARGE USING CHARGING CHARTS

GENERAL

jSET ECONOMIZER MINIMUM VENT AND CHANGEOVER SETTINGS TO MATCH JOB REQUIREMENTS (IF EQUIPPED)

Copyright 2006 Carrier Corp. S 7310 W. Morris St. S Indianapolis, IN 46231	Printed in U.S.A.	Edition Date:09/06	Catalog No:50H-1SI
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.			Replaces:50HJ--31SI

72