Use the [+] and [–] buttons or the number buttons to input the parameter setting you want.
E-29
2.
After selecting the chorus type you want, use the [ ] and [ ] CURSOR buttons to display the parameter whose setting you want to change.
1.
Š See the list on page A-18 for information about the types of CHORUS effects that are available.
Š Here you could also change the parameters of the effect you selected, if you want. See “Changing the Settings of CHORUS Parameters” for more information.
Changing the Settings of CHORUS Parameters
You can control the relative strength of an effect and how it is applied. The parameters you can control depend on the effect. See the following section titled “CHORUS Parameters” for more information.
Use the [+] and [–] buttons or the number buttons to scroll through the chorus types until the one you want is displayed, or use the number buttons to input the chorus number you want to select.
4.
The chorus type setting screen will appear automatically about fives seconds after you press the button.
Š
Press the [ ] CURSOR button.
This displays the chorus editing screen.
Š
Press the [
] CURSOR button twice.
1. Press the EFFECT button, so the pointer appears next to EFFECT on the display screen.
2.
3.
Same as Reverb Type
Š Whether or not an effect is applied to the parts that are sounding also depends on Mixer Mode Reverb Send, Chorus Send, and DSP on/off settings. See “Mixer Function” on page E-39 for more information.
Selecting CHORUS
Perform the following steps to select CHORUS.
High Damp
z
Applying Effects to Tones

CTK691E01-01.book 29 ページ ２００３年９月２９日 月曜日 午後４時４７分

1. After selecting the reverb type you want, use the [ ] and [ ] CURSOR buttons to display the parameter whose setting you want to change.

ŠThis displays the parameter setting screen.

Example:

To set the Reverb Time parameter

2. Use the [+] and [–] buttons or the number buttons to input the parameter setting you want.

3. Press the EFFECT or EXIT button.

ŠThis returns to the tone or rhythm selection screen.

REVERB Parameters

Reverb effects are associated with either a reverb type or delay type. Parameter settings depend upon the associated type.

„Reverb Type (No. 0 to 5, 8 to 13)

zReverb Level (Range: 000 to 127)

Controls the reverb size. A larger number produces larger reverb.

zReverb Time (Range: 000 to 127)

Controls how long reverb continues. A larger number produces longer reverb.

zER Level (Initial Echo Sound) (Range: 000 to 127)

This parameter controls the initial reverb volume. The initial echo sound is the first sound reflected from the walls and ceiling when a sound is output by this keyboard. A larger value specifies a larger echo sound.

zHigh Damp (Range: 000 to 127)

Adjusts the damping of high frequency reverberation (high sound). A smaller value damps high sounds, creating a dark reverb. A larger value does not damp high sounds, for a brighter reverb.

„Delay Type (No. 6, 7, 14, 15)

zDelay Level (Range: 000 to 127)

Specifies the size of the delay sound. A higher value produces a larger delay sound.

zDelay Feedback (Range: 000 to 127)

Adjusts delay repeat. A higher value produces a greater number of repeats.

zER Level

Same as Reverb Type

705A-E-031A