MarginsYou can select from among the following four margin settings.NoteAll of the margin measurements mentioned below are approximate.NARROW

3.0mm (1/8")

3.0mm (1/8")

MEDIUM

10mm (3/8")

10mm (3/8")

WIDE

21.5mm (7/8")

21.5mm (7/8")

Important!

Margins are not cut in the case of short tape lengths 31mm (1 1/4") for NARROW, 38mm (1 1/2") for MEDIUM, 50mm (1 15/16") for WIDE). After printing, you can use scissors to trim to the margin you want.

NONE

Setting with the NONE setting makes it possible to print consecutive labels one after another.

The auto tape cut operation is not performed when NONE is selected for the margins. To cut the tape, press FUNCTION and then CUT.

FREE DESIGN: Controlling the Length of a Tape Label

Tape label length is normally adjusted in accordance with the size and number of the characters in the label. This section explains how you can control the length of your labels.

There are two different ways to control label length:

Specifying the length of each block contained in the label (fixed block length);

Specifying the overall length of the label (fixed tape length).To control label length using fixed block lengths

1.In the Free Design Mode, input the text you want, and divide it into blocks as required.

See page 22 for information about blocks.2.Move the cursor to the block whose length you want to fix.

The cursor can be located anywhere within the block.

3.Press FORM.

If your label has only one block, advance directly to step 6 of this procedure.

4.Use and to select BLOCK FORM, and then press SET.

5.Use and to select ONE BLOCK, and then press SET.

If you want to apply your setting to all of the blocks in your label, select ALL BLOCKS instead.

6.Use and to select B-LENGTH.7.Use and to change the setting to FIX.

27E