PLAYBACK

To re-record audio

1.In the PLAY mode, use [] and [] to scroll through snapshots until the one whose audio you want to re-record is displayed.

2.Press [MENU].

3.Select the “PLAY” tab, select “Dubbing”, and then press [].

4.Use [] and [] to select “Delete”, and then press [SET].

•If you merely want to delete the audio without re- recording, press [MENU] here to complete the procedure.

5.Press the shutter button to start audio recording.

6.Recording stops after about 30 seconds or when you press the shutter button.

•This deletes the existing audio and replaces it with the new one.

IMPORTANT!

 

• Keep the microphone

Microphone

on the front of the

 

camera pointed at the

 

subject.

 

•Take care that you do

not block the microphone with your fingers.

•Good recording results are not possible when the camera is too far from the subject.

•Operating camera buttons during recording can cause button noise to be included in the audio.

•The (Audio) icon appears on the monitor screen after audio recording is complete.

•You will not be able to record audio when remaining memory capacity is low.

•The following types of audio recording are not supported.

—Adding audio to a movie image

—Adding audio to a protected snapshot (page 181)

•Audio that is re-recorded or deleted cannot be recovered. Make sure you no longer need audio before re-recording or deleting it.

174