
3.Remove the stopper from a new tape cartridge and check to see that the tape is ready to use.
•Make sure that the tape is under the tape guide and that it is not bent or twisted.
•Make sure that the tape does not extend too far past the tape guide. If it does, cut off the end with a pair of scissors.
4.Use a pencil or some other thin object to take up slack in the ink ribbon as shown in the illus- tration. Note that the tape does not move at this time.
•If the ink ribbon is slack when you load it into the Label Printer, it can break or cause some other problem.
Tape guide
13