
To change attributes in the middle of text
1.Input text using the initial attributes.
2.Perform one of the character attribute change operations.
•See the following pages of this manual for details on specifying attributes. Font – page 29
Style – page 30 Size – page 32
•Whenever you perform an attribute change operation after inputting some text, a message appears asking from where you want to begin the change.
3.Press SET.
•This causes a message to appear asking up to which point you want the change to take effect.
4.Press SET.
•Note that you should specify the points for FROM? and TO? in this operation.
•Any characters you now input will use the attributes you specified in step 2, above.
•If you change the character size, a symbol appears
to show where the size change takes place. | FUNCSHIFT | 1✕1 |
|
| |||
| CODE | 4 1cm | |
| VERT |
|
|
MIROR ab1
OVER ✕
CAPS 1
To change attributes or effects of existing text
1. After inputting text, perform one of the character attribute or text effect change opera- tions.
• See the following pages of this manual for details on actually specifying attributes. Font – page 29
Style – page 30 Size – page 32
Text effects – page 34
• Whenever you perform an attribute or effect change operation after inputting text, a message appears asking from where you want to begin the change.
2. Use H and J to move the cursor to the point where you want the change to start.
3. Press SET.
• This causes a message to appear asking up to which point you want the change to take effect.
4. Use H and J to move the cursor to the point up to which you want the change to take effect.
• Note that the text that will be affected by the change is highlighted as you move the cursor.
• Note that the TO? point can be either to the left or to the right of the FROM? point.
28