Projection Operations

3. Use the [W] and [X] keys to correct for keystoning.

zEach press of [W] or [X] shifts the indicator on the currently selected bar left or right.

zRepeat steps 2 and 3 to perform keystone correction for the other direction, if you want.

4.After the settings are the way you want, press the [ESC] key or the [KEYSTONE] key.

zThis causes the keystone correction screen to disappear.

Auto Focus (AF)

At times, the projector may not focus properly when you press the [AF/AK] key. This can be caused by local environmental factors, etc. If this happens, focus the image manually or try performing the AF operation again. If you often need to adjust focus manually, perform the steps under “To adjust Auto Focus”, below.

Note that the allowable distance for Auto Focus is less than that for manual focus.

To adjust Auto Focus

1. Position the projector and screen so they are about 1.5 meters apart, and then press the [ ] (power) key to turn on the projector.

zPosition the projector so it is pointed straight at the screen.

2.Press the [AF/AK] key.

3.Press the [KEYSTONE] key and then use the screen that appears to change the vertical and horizontal keystone correction values to zero.

zThis step is not necessary if these values are already zero.

4.Use the [FOCUS] keys to adjust focus manually.

5.While the focus indicator is being projected, hold down the [ENTER] key for about five seconds.

zAfter about five seconds, the message “Focus operation successful.” or “Focus operation failed.” is projected.

6.If the focus operation fails, repeat the above procedure from step 2.

11