Using the Setup Menu

Image Adjustment J Noise Filter

This sub-menu provides a choice of noise filter levels to remove digital noise from the projected image when RGB is selected as the input source. Note that the noise filter may not be able to remove certain types of digital noise.

zThis setting is possible only when RGB is selected as the input source. The setting is saved for the RGB input source only.

zTurning off the projector automatically returns this sub-menu to its initial default setting (Normal).

Input Source Specific Menu Items

Input Source

Available Items (Parentheses indicate defaults.)

 

 

RGB

Low, (Normal), High

 

 

Component

None

 

 

S-VIDEO

 

 

 

VIDEO

 

 

 

No Signal

 

 

 

Image Adjustment J Restore Menu Defaults

This sub-menu returns all of the sub-menu items on the Image Adjustment main menu to their initial default settings.

zYou can perform initialization even when there is no input signal. In this case, the initialization is performed for the currently selected input source.

z“Image Adjustment” main menu “Vertical Position”, “Horizontal Position”, “Frequency”, and “Phase” settings are initialized for the current signal type (XGA/60Hz, SXGA/60Hz, etc.) only.

zFor details about the initialization procedure, see “To initialize the settings of a particular main menu item” on page 29.

Volume Adjustment

Volume Adjustment J Volume

This sub-menu can be used to adjust the volume level of the projector’s speaker. This setting is also linked to volume settings made with the remote controller’s [VOL +] and [VOL –] keys.

zChanging this setting when there is no input signal changes the volume setting of the currently selected signal source.

zA different setting is stored for each input source.

Volume Adjustment J Restore Menu Defaults

This sub-menu returns Volume to its initial default setting.

zYou can perform initialization even when there is no input signal. In this case, the initialization is performed for the currently selected input source.

zInitialization is performed separately for each input source.

zFor details about the initialization procedure, see “To initialize the settings of a particular main menu item” on page 29.

35